How to Make a Rose Pendant Using Polymer Clay

Roses are also fun flower pendants that look lovely when worn. They are also easy and fun to make, and all you will need for this pendant is a large ball of red clay, a medium ball of green clay, a skewer and a knife.

Wrap a small cylinder of green clay around the skewer. Next take two small green balls and press them slightly flat. To create a leaf shape, pinch both sides of the green shapes so they look like a diamond. Use the knife to cut a line down the middle of each leaf, but make sure to not push so hard because you are only adding detail; you are not cutting the leaf in half.

When you are making the leaves for this flower you can add some detail to make it look more like a rose. Use the knife to add a pointy edge to the leaves. This can be achieved by simply pushing the edge of the knife into the edge of the leaf. Skip a spot and repeat all the way around the edge. Attach the leaves to the green ring.

To make the rose you will need to roll the red clay out into a long tube. Next use your knife to cut the tube into sections; when doing this part start by cutting a small section, and slowly increase the size of the section. You should end up with about six petals depending on how big your rose is going to be. Roll these sections into balls, and using your thumb press the ball flat.

Start making your rose by rolling the small its petal into a spiral like shape. Next use your second smallest petal to wrap half way around the spiral; use the third smallest petal to slightly overlap the second petal and slowly move around the base petal. Keep wrapping petals around until you run out of petals. Finally bend some of the petals out from the middle to make the rose look like it is blooming. If you want to make it look like a rose bud leave the petals the way they are.

Flatten the bottom of the rose by holding the sides and pressing it against a table or other flat surface. Now use the knife to make some cross hatched marks in the flat part of the rose. Make similar marks at the part of the green circle that you are going to attach the flower to. Push these two pieces together. If you have some liquid clay you can brush some onto the hatch marks before you push them together.

Bake the pendant in the oven for about 15 minutes, and allow to cool before removing the skewer. When the pendant is done string it on some ribbon, and you will love wearing this polymer clay rose pendant.